Samsung Fmwareir

I8190NXXAMJ2 Android 4.1.2 JB Firmware Download


I8190NXXAMJ2 Android 4.1.2 JB Firmware For Galaxy S3 mini I8190N – How To Guide

The official update Samsung S3 MINI GT-I8190 Firmware for the I8190NXXAMJ2 Android 4.1.2 JB Firmware  is available for download through the official download links provided below.

Follow these steps to enter download mode mode / Odin

  1. Turn off your device
  2. Press and the key to decrease the volume_ retention, Home key and power key
  3. When the device vibrates, release power button while still holding the Volume Down key and Home key


Warning before entering into download mode
Step 4:Press Volume Up to enter download mode, which has a green figure robot and “Downloading … Do not turn off target .


Now it is in download mode
Step 5: Connect the device to PC.
You device should be automatically recognized by Odin. In the lower left corner Odin interface, you should show a message saying “Added!” and meanwhile you should see a blue light in the ID: COM section that says “COM 3” (the number depends on which USB port you have connected the device cable and is irrelevant.



The device is connected to Odin
Step 6: Click “PDA” or “AP” to add the file tar.md5 you extracted and then “Start”.
Whether it’s “PDA” or “AP” it depends on the version of Odin used. But the md5 file will either “PDA” or “AP”.


Add md5 * to Odin
After adding the file, click “Start” to begin the flashing process.


Click “Start” to flash
WARNING Do not remove or operate on until completed or failed device is shown in ODIN.



Process intermittent course. Do not remove the device
When the process is done flashing and, if all goes well, you should see a green box that says “RESET” or “past” (depending on the version of Odin used). For now, the device must be restarted and it is safe to remove / disconnect the device.


Flash succeeded


About the author


Leave a Comment